D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 12 of 90
Some engines may be equipped with a factory installed exhaust riser. Verify that the
riser provides the required dimension “c”, or a distance greater than “c”, as indicated.
Model (c) = (a) Minus (b)
All Models (c) Must Be 13 in. (330 mm) or More
merCruiser
a
c
d
b
76076
Typical Engine With Riser
a-From Waterline to Top of Transom
b-From Highest Point on Exhaust Riser to Top of Transom
c-Equals (a) minus (b)
d-Waterline At Rest
Fuel Delivery System
WARNING
Boating standards (NMMA, ABYC, etc.) and Coast Guard regulations must be ad-
hered to when installing fuel delivery system.
GENERAL
The main concern of a boat’s fuel system is safety; this must be achieved through a techni-
cally sound installation and constant inspection.
The fuel system, from the filler pipe to the fuel pump is the same, in principle, for all boats.
The Fuel Tank is an integrated component of the boat. Refer to the special information on
service and maintenance, which you have received from the thank manufacturer.
Only a few points related to function and safety are listed here [Refer to boating standards
(NMMA, ABYC, etc.) and Coast Guard regulations for complete guidelines]:
1. All connections should be on the upper side of the tank.
2. The drain plug at the lowest point on the tank serves to permit the removal of water and
sediment.
3. The filler pipe outer diameter should be at least 2 in. (50mm).
To Next Page
Loading...
Need help?
General