D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 60 of 90
Throttle Cable Installation and Adjustment
IMPORTANT: When installing throttle cables, be sure that cables are routed in such a way as to avoid
sharp bends and/or avoid contact with moving parts. DO NOT fasten any items to throttle cables.
1. Place remote control lever(s) in neutral/idle position.
2. Measure between the center of the Accelerator Position Sensor anchor stud to the holes
on the cable barrel end bracket. Select the hole in the cable barrel end bracket that
is closest to the distance of 7-1/8 in. (181 mm) between studs.
76025
a
b
c
d
e
a-Accelerator Position Sensor (APS/IVS)
b-APS/IVS Anchor Stud
c-Cable Barrel End Bracket
d-Cable Barrel Anchor Stud
e-7-1/8 in. (181 mm)
3. Install cable end guide on throttle lever, then push cable barrel end lightly toward throttle
lever end.
(This will place a slight preload on shift cable to avoid slack in cable when
moving remote control lever).
Adjust barrel on throttle cable to align with stud in anchor
bracket. Ensure hole in barrel positions cable as shown. Install cable and secure with
hardware as shown.
To Next Page
Loading...
Need help?
General