D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 70 of 90
22031
a
a-Fill Neck
3. Check all trim line connection points for leaks. If fluid is visible at fittings, tighten fitting(s).
Torque fitting(s) to 100-150 lb-in. (11-16 Nm).
Trim Position Sender Adjustment
1. Loosen both trim position sender attaching screws.
71220
a
b
a-Attaching Screws
b-Trim Position Sender
CAUTION
DO NOT start engine in the following step or damage to drive unit and engine could
result from lack of cooling water.
2. Turn ignition key to RUN position.
3. Trim drive unit to the full DOWN/IN position.
To Next Page
Loading...
Need help?
General