4.2 HOW TO OPERATE YOUR SCOOTER
• Ignition Switch
• The ignition switch is operated by the key supplied, and is located on the right hand side of the
tiller below the front indicator lamp.
• To switch the scooter on, insert the key and turn 90° clockwise
• To switch the scooter off, turn the key 90° anticlockwise and remove (note that the key cannot be
removed whilst the scooter is switched on.
• Forward, Reverse and Braking
• Push the wigwag paddle forwards with your right thumb and the vehicle will move forward.
• Push the wigwag paddle forwards with your left thumb and the vehicle will move backward.
• The horn will sound when the vehicle is reversing.
• Release the wigwag paddle freely while moving, and the electromagnetic brake in the motor will
be activated. The rear brake lights will also illuminate when the electromagnetic brake is operating.
• The controls can be reversed for left-handed people or those who do not have full use of their right
arm. Please enquire with your dealer about this setting.
• Manual Brake
As well as an electromagnetic brake, the M48 GT has a manual cable brake. Squeeze the brake lever
to apply the brake then release the lever to release the brake.
• Speed Dial
• The position of this dial determines the maximum attainable speed of the scooter.
• Turn the dial clockwise to increase the maximum speed, or turn the dial anticlockwise to reduce
the maximum speed attainable.
To Next Page
Loading...
Need help?
General
