Wheeltech Monami and Vitesse electric scooters Part Code: Z40961-00 (Rev B)
Owner’s Handbook Page 20 of 24
8.2 ASSEMBLING THE SCOOTER
Suggestions
The assembly process is essentially the disassembly process in reverse. First study the text and photographs
in the disassembly procedure before re-assembling the scooter.
1. Position the front and rear sections of the scooter.
2. Align the lower curved locking brackets of the front section with the corresponding pegs on the front of
the rear section.
3. Holding the seat post, slowly pivot the rear section forward until the curved locking brackets are fully
connected on to the top rear pegs.
4. Secure the lock pin in to the pin hole
5. Loosen the tiller adjustment knob, raise the tiller to the desired position, and then tighten the tiller
adjustment knob.
6. Reinstall the batteries and secure them with the Velcro strap.
7. Connect the front-to-rear harnesses and battery cables.
8. Reinstall the rear shroud.
9. Replace the seat and rotate it until it locks in to its correct position.
Warning
After assembling the scooter, make absolutely certain the tiller adjustment knob is fully tightened.
To Next Page
Loading...
Need help?
General
