75/90/115 OPTIMAX
Page 14 of 18
Throttle Cable Installation
Install cables into the remote control following the instructions provided with the remote con-
trol.
1. Position remote control into neutral.
N
2. Install throttle cable to the throttle arm with washer and locknut.
3. Adjust the cable barrel so that the installed throttle cable will hold the throttle arm against
the idle stop.
4. Place cable barrel into retainer.
5. Lock the retainer and cables in place with the cable latch.
a
b
c
d
e
a-Flat Washer
b-Locknut – Tighten lock-
nut then back off lock-
nut 1/4 turn
c-Barrel Retainer
d-Cable Barrel
e-Cable Latch
To Next Page
Loading...
Need help?
General
