5
Table of Motherboard Components
Label Component
AGP1 ADD slot
ATX1 Standard 20-pin ATX power connector
ATX12V Power connector
AUDIO1 Front panel MIC/Speaker Out header
AUXIN1 Auxilliary In header
CDIN1 Primary CD-in connector
CNR1 Communications and Networking Riser slot
CASFAN1 Case fan connector
CPUFAN1 Cooling fan for CPU
CPU Socket CPU socket (mPGA478)
DIMM1 ~ DIMM2 Two 184-pin DDR sockets
FDD1 Floppy disk drive connector
IDE1 Primary IDE channel
IDE2 Secondary IDE channel
JP1 Clear CMOS jumper
JP3 BIOS flash protect jumper
PANEL1 Panel connector for case switches and LEDs
PCI1 ~ PCI3 Three 32-bit add-on card slots
SPDIF SPDIF out header
SPEAKER1 Speaker header
USB2 Connector for front panel USB ports
This concludes Chapter 1. The next chapter explains how to install the moth-
erboard.
To Next Page
Loading...
Need help?
General
