90-8M0168272 eng DECEMBER 2019 © 2019 Mercury Marine Page 1 / 5
VESSELVIEW MOBILE MODULE
IMPORTANT: This document guides our dealers, boatbuilders, and company service personnel in the proper installation or
service of our products. If you have not been trained in the recommended servicing or installation procedures for these or
similar Mercury Marine products, have the work performed by an authorized Mercury Marine dealer technician. Improper
installation or servicing of the Mercury product could result in damage to the product or personal injury to those installing or
operating the product. Always refer to the appropriate Mercury Marine service manual for component removal and installation
instructions.
NOTE:
After completing installation, place these instructions with the product for the owner's future use.
Components Contained in Kit
Ref. Qty. Description Part Number
a 1 Cable clip 23567
b 2 Screw 69013
c 1 VesselView Mobile module with harness NSS
d 1 Weather cap 859318T2
e 4 Cable tie 816311T
VesselView Mobile Module Connection
Engine‑Mounted Module
NOTE: The location of the engine harness 10‑pin connector and terminator will vary depending on the engine model.
1. Depending on the engine model and rigging configuration, the engine harness 10‑pin connector will be equipped with a
purple weather cap, a yellow terminator, or a red terminator.
To Next Page
Need help?
General
