VESSELVIEW MOBILE MODULE
Page 4 / 5 © 2019 Mercury Marine 90-8M0168272 eng DECEMBER 2019
1. Locate the multiwake junction box.
a - Multiwake junction box
b - Weather cap
c - Cable clip
d - VesselView Mobile module with
harness
2. Select a suitable location for mounting the VesselView Mobile module and harness.
3. Use a 3/32 drill bit to drill two pilot holes to mount the VesselView Mobile module and the harness cable clip.
4. Install the VesselView Mobile harness 10‑pin connector into the multiwake junction box.
IMPORTANT: The harness cable clip should be positioned on the harness and slid up close to the module. It may then
be secured to the surface with a screw. The cable tie straps should be used to secure the main harness and terminator
extension.
5. Mount the VesselView Mobile module with the supplied mounting screws, cable clip, and cable ties.
Bluetooth Pairing
1. Download the VesselView Mobile app from Apple® iTunes® or the Google Play™ store.
2.
Turn the key switch(es) to the ON position.
3. Verify the SmartCraft LED on the module goes solid green shortly after key up. The Bluetooth LED should be flashing
letting you know the module is ready to pair. If the SmartCraft LED is off, this means no engine data is detected by the
module which is commonly caused by incorrect termination resistor placement.
4. Open the app and follow the on‑screen instructions to connect.
Electrical Specifications
IMPORTANT: The documentation must be consulted in all cases where the symbol
!
, is marked.
IMPORTANT:
!
Always refer to the Operation Manual included with each engine for fuse holder location, fuse rating, and
electrical system overload protection.
This equipment is only intended for connection to 9–16 Vdc, low voltage, electrical systems of boats or similar marine vessels.
Do not connect this equipment to any circuit rated in excess of 16 Vac rms, 22.6 Vpk or 35 Vdc, and only connect to boat
electrical systems powered by batteries or alternators or otherwise only to circuits separated from main voltages by at least
double or reinforced insulation.
Overload and Fuse Protection
IMPORTANT:
!
Always refer to the Operation Manual included with each engine for fuse holder location, fuse rating, and
electrical overload protection.
To Next Page
Loading...
Need help?
General
