Mercury VesselView Mobile Quick Start Guide

VESSELVIEW MOBILE MODULE
90-8M0168272 eng DECEMBER 2019 © 2019 Mercury Marine Page 3 / 5
4. Remove the weather cap from the VesselView Mobile harness terminator connector and install the removed yellow or red
terminator into the VesselView Mobile harness terminator connector.
a - Weather cap
b - VesselView Mobile harness terminator connector
c - Yellow terminator
IMPORTANT: The VesselView Mobile harness must not contact the flywheel, throttle and shift components, or other
moving parts. Care must be taken to assure that the module and its wiring harness are not in close proximity to the high
voltage ignition leads and do not interfere with the throttle or shift mechanisms.
5. Identify an appropriate location and routing path on the engine for the VesselView module and harness. Secure the
module and harness to the engine at the selected location with cable ties.
a - Engine harness terminator
connector
b - Terminator
c - VesselView Mobile module
Helm‑Mounted Module
The VesselView Mobile module can be mounted at the helm if the vessel is equipped with a junction box and open
connection point. The module can also be mounted on the engine.
IMPORTANT: Multiple engine applications may be equipped with more than one junction box. Always connect the
VesselView Mobile module to the multiwake junction box on vessels equipped with multiple engines. The multiwake junction
box has unswitched 12 V power from the starboard battery.
69261
a
b
c
62813
a
b
c

Mercury VesselView Mobile Specifications

General

Brand	Mercury
Model	VesselView Mobile
Category	Control Unit
Language	English