Metabo KS 66 FS User Manual

ENGLISHen
14
A defective mains cable must be replaced only with
a special, original mains cable from Metabo
available from the Metabo service.
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.
Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
P
1
=Rated input
P
2
=Power output
n
0
=No-load speed
n
1
=On-load speed
T
max
=maximum depth of cut
T
90°
=max. depth of cut (90°)
T
45°
=max. depth of cut (45°)
A =adjustable angular cut angle
Ø =saw blade diameter
d =saw blade drill diameter
a =max. base body thickness of the saw
blade
b =cutting width of the saw blade
m=weight
Measured values determined in conformity with
EN 62841.
Machine in protection class II
~ AC Power
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value
(vector sum of three directions)
determined in accordance with EN 62841:
a
h, D
=Vibration emission value
(Sawing chip board)
K
h,D
=Uncertainty (vibration)
Typical A-effective perceived sound levels
:
L
pa
= Sound-pressure level
L
WA
=Acoustic power level
K
pA
, K
WA
= Uncertainty
The noise level can exceed 80 dB(A) during
operation.
Wear ear protectors!
13. Environmental Protection
14. Technical Specifications

Metabo KS 66 FS Specifications

Technical Specifications

rated input	P1
power output	P2
no-load speed	n0
on-load speed	n1
maximum depth of cut	Tmax
max. depth of cut (90°)	T90°
max. depth of cut (45°)	T45°
adjustable angular cut angle	A
saw blade diameter	Ø
saw blade drill diameter	d
max. base body thickness of the saw blade	a
cutting width of the saw blade	b
weight	m