Portable 2000 count digital multimeter
16
∗ If any faults or abnormalities are observed, take the instrument out
of
service and ensure that it cannot be used until it has been
checked out.
∗ It is recommended to remove the battery from the instrument if not
used.
1.2 Protection
mechanisms
This instrument is fitted with various protection mechanisms :
∗ Varistor protection for limiting transients of over 600 V at the VΩ
terminal, particularly 6 kV pulse streams as defined by the French
standard IEEE 587.
∗ A PTC (positive temperature coefficient) resistor protects against
permanent overvoltages of up to 600
V during resistance,
continuity and diode test measurements. This protection is reset
automatically after overload.
∗ An IP protection rating of 40.
1.3 Safety
mechanisms
∗ The battery unit cannot be accessed without first disconnecting
the measuring leads.
∗ If the maximum range is repeatedly exceeded, an intermittent
audible signal w
arns the user in V
AC, VDC, mVDC, mVAC, IDC,
functions.
1.4 Warranty
This equipment is warranted against any defects of manufacture or
materials according to the general conditions of sale.
During the warranty period (1 year), defective parts will be replaced,
the manufacturer reserving the right to repair or replace the product. In
the event of the equipment being returned to the after sale department
or to a local agency, carriage to the centre shall be payable by the
customer. The warranty does not cover the following :
1. Repairs necessitated by m
isuse of the equipment or use
in
association with incom
patible equipment.
2.
Modification of the equipm
ent or any related software without the
explicit authoriz
ation of the manufacturer.
3.
Repairs necessitated by attempts to repair or ma
intain the product
made by a person not approved by the manufacturer.
4.
Adaptation to a specific app
lication not provided for in the
specifications of the equipm
ent or the user manual.
5.
Damage after a drop, a shock or flooding.
To Next Page
Loading...
Need help?
General
