Metrohm Autolab 8 Series User Manual

Insert new module for the Autolab 8-Series
6 | Page
Figure 3 – Open the cabinet by sliding the cover of the cabinet
4. Lift the top cover and remove it from the instrument and disconnect the earth
cable (see Figure 4).
Figure 4 – Lift the cover
Now the analog bus can be reached from the top. If you do not have to install a module,
it is unnecessary to remove the front panel of the instrument. If a new module needs to
be installed in the instrument, it is necessary to remove the front panel.
Follow these steps to remove the front panel:
1. Unscrew the four screws, indicated in Figure 5, holding the front panel to the
frame from the mounting tabs.

Metrohm Autolab 8 Series Specifications

General

Brand	Metrohm
Model	Autolab 8 Series
Category	Measuring Instruments
Language	English