Midea Cube MAD User Manual

 Page 8 
Installation
Instructions
Positioning the Unit
The dehumidifier should be placed in the area where dehumidification is desired most.
Adjacent rooms in which dehumidification is also desired should allow adequate
airflow in and out of the space containing the dehumidifier.
• Do not use outdoors.
• This dehumidifer is intended for
indoor residential applications
only. This dehumidifier should
not be used for commercial or
industrial applications.
• Place the dehumidifier on a smooth,
level floor strong enough to support
the unit with a full bucket of water.
• Allow at least 8” of air space on all
sides of the unit for air circulation
(at least 16” for air outlet).
• Place the unit in an area where
the temperature will not fall below
41°F (5°C). The coils can become
covered with frost at at lower
temperatures, which may reduce
performance.
• Place the unit away from any
clothes dryer, heater or radiator.
• Close all doors, windows, and
other openings to the outdoors in
the room.
Fig. 5
Fig. 6
More
than
16”
More than 8”
More than 8”
More than
8”
More than
8”
INSTALLATION INSTRUCTIONS
Optional Caster Installation
To install the casters:
1. Remove the Dehumidifier from the bucket.
2. Slide each caster into the slot on the bucket’s bottom corner as shown below.
3. Place the retaining block into the slot to hold the caster in place.
4. Repeat this for each corner of the bucket until all 4 casters are installed.
blockcaster
bottom
of unit

Midea Cube MAD Specifications

General

Brand	Midea
Model	Cube MAD
Category	Dehumidifier
Language	English