10
19
Troubleshooting
• After checking, try to use the appliance again. If the problem persists
or the display shows other alarm codes again, contact the service center.
Note!
Description
Reason
Solution
Check the water tap is
opened or not.
Alarm for abnormal
water filling.
Alarm for lid not closed
before wash and spin.
Close the lid.
MAINTENANCE
flashes/
blinks
flashes/
blinks
Description
No washing
Inspection Items
If the power is o or the fuse is burned out.
If the water reache required water level.(The washer will
not work if the water amount does not reach the required water level)
The power supply volteg is too low.
volume the
No water flows in
If the power is o or the fuse is burned out.
If the water supply is cut o or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the ltering screen of inlet valve is blocked by dirt.
If the coil of the inlet valve is damaged.
If the "Start / Hold" button is pressed after the power switch is pressed.
Abnormal draining
If the end of the water drain hose is placed very high.If the end of
water drain hose is immersed in and blocked by a pool of water.
If the internal rubber ring of drain valve is blocked by dirt.
Abnormal spin
If the lid is closed.
If
If the washer is not placed in stable condition or it is placed
state. (The ground is not at).
top
most of the clothing are at one side of the drum or if too many
clothes are loaded in the machine.
an inclined
If the appliance does not start or it stops during the operation, initially try to
nd a solution to the problem based on the table below. Otherwise, contact
the service center.
flashes/
blinks
flashes/
blinks
Unbalanced wash load
during spinning
Evenly distribute the clothes in
the drum by hand.
Check the water level
sensor and drain pump.
Alarm for water
unfinished water draining
To Next Page
Loading...
Need help?
General