9
10
Levelling the washing machine
Connect Water Supply Hose
Connect the inlet pipe as indicated, There are two ways to connect the inlet pipe.
1.Connection between ordinary tap and inlet hose.
2
3
4
1
Raise
Lower
Lock
nut
foot
Warning!
Loosen clamp nut
and four bolts
Press the tap end
against the rubber ring
inside the clamp then
tighten the 4 screws.
Press slide bushing,
insert inlet hose into
connecting base
slide bushing
2
3
41
Connection finished
clamp nut
Tap with threads and inlet hose
Special tap for washing machine
2.Connection between screw tap and inlet hose.
slide bushing
INSTALLATION
• The lock nuts on all four feet must be screwed tightly against the housing.
1.Check if the legs are closely attached to the cabinet. If not, please
turn them to their original position then tighten the nuts.
2.Loosen the lock nut then turn the feet until it closely contacts with the floor.
3.Adjust the legs and lock them with a wrench, make sure the
machine is steady
Warning!
• To prevent leakage or water damage, follow the instructions below.
Do not kink, crush, modify or cut the water inlet hose.
To Next Page
Loading...
Need help?
General