Midea HORIZONTAL Series User Manual

Methods of using
Operating Of The Unit
OPERATION INSTRUCTIONS
During normal operation, the inlet valve shall be always kept open.
First, open any one of the outlet valves at the outlet of the water heater, then, open the
inlet valve. The water heater gets filled with water. When water flows out of the outlet
pipe it implies that the heater has been filled fully with water, and the outlet valve can be
closed.
1.
If the “Power” indicator lights up, the thermostat will automatically control the tempera-
ture. When the water temperature inside the heater has reached the set temperature, it
will switch o automatically, when the water temperature falls below the set point the
heater will be turned on automatically to restore the heating.
2.
“Thermostat” knob, rotate the thermostat knob to set the temperature. Maximum set
temperature is 75 °C. Then the heating indicator light on.
“Power” indicator light, plug in the power, the power indicator light will light ON reserva-
tion.
“Heating indicator ” light, when the water is heated to the set temperature. The indicator
light is o, the water heater will be in a state of insulation.
1.
2.
3.
(Fig.6)
10
Note
1
2 3

Midea HORIZONTAL Series Specifications

General

Brand	Midea
Model	HORIZONTAL Series
Category	Water Heater
Language	English