Service manual for portable washer Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
－ 11 －
4. TROUBLE SHOOTING
4.1 Test mode by Control
Note: Before entering the test mode, you should empty the machine so that there is no
water left in the tub. You can run a Spin Only cycle or operate as following steps to get all
water out. Then make sure all parts are in their original position for check running.
Step 1：Lay the drain hose down to insert the end of the hose into an
outfall on floor.
Step 2: Remove the Back Panel from the unit.
Step 3: Find the Drain Valve and pull the bar and keep pulling as the
arrow direction as right figure.
Step 4: Wait for the water to be drained out.
Now, the unit is ready for test check.
To Next Page
Loading...
Need help?
General