Service manual for Washing Machine Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
- 21 -
4.5 Trouble shooting
You can check for a quick solution as following table.
- Make sure your washer is plugged in.
- Make sure the lid is closed.
- Make sure the water source faucets are open.
- Make sure to press the Start/Pause button to start your
washer.
- Make sure Child Lock is not activated.
- Check if a Delay Start is set.
- Before your washer starts to fill, it will make a series of
clicking noises to check the lid lock and go a quick drain.
No water or not enough water.
Detergent / Softener remains
in its box after the wash cycle is
completed.
- Turn both faucets on fully.
- Check if the water pressure is in the range .
- Straighten the water inlet hoses.
- Disconnect hoses and clean the screens. Hose filter
screens may be clogged.
Vibrates or is too noisy.
- Make sure your washer is set on a level surface. If the
surface is not level, adjust your washer’s feet to level the
appliance.
- Make sure your washer is not touching any other object.
- Make sure the laundry load is balanced.
During the spin process, if clothes are piled at one side of
basket, it will stop due to imbalance. The unit will try to solve
the problem automatically. If the washer can’t solve the
problem in three trials, you should replace the clothes and
make it as even as possible manually.
- Plug the power cord into a live electrical outlet. Check the
fuse or reset the circuit breaker.
- Close the lid and press the Start/Pause button to start your
washer. For your safety, your washer will not spin unless the
lid is closed.
- Before your washer starts to fill, it will make s series of
clicking noises to check the lid lock and do a quick drain.
- There may be a pause or sock period in the cycle. Wait and
it may start.
- Check the screens on the inlet noses at the faucets for
obstructions. Clean the screens periodically.