Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
1. Switch on the appliance;
2. Press the Start/Pause button for more than 5 seconds to start the water softener set
model within 60 seconds after the appliance was switched on;
3. Press the Start/Pause button to select the proper set according to your local
environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6;
4. Without any operation in five seconds, the machine will exit from set mode, the
machine is into standby status.
Please follow the steps below for adjustment in salt consumption.
6
1) German degree of measurement for the water hardness
2) millimol, internationel unit for water hardness
* factory setting
0 - 5
6 - 11
12 - 17
18 - 22
23 - 34
35 - 45
dH
dH
0 - 0.9
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.1
6.2 - 8.0
Mmol/lMmol/l
Digital display stalls
WATER HARDNESS
H1
H2
H3
H4
H5
H6
Setting on the
water softener
1
2
3
4
5
6
1) 2)
*
To Next Page
Loading...
Need help?
General
