Cleaning and care
58
Pull off the upper silicone section
with the aperture for the milk
pipework.
The grey silicone section contains a
black, cylindrical component. Pull
out the black component.
Remove the dispensing spouts.
Clean all parts thoroughly.
Clean the surfaces of the central
spout with a damp cloth.
To effectively remove coffee deposits,
clean the coffee pipework with the
cleaning brush once a month.
Angle the cleaning brush slightly and
clean both spouts from above and
below.
Reassembling the central spout
The dispensing unit is easier to
reassemble if the individual parts are
dampened with water.
Reassemble the dispensing unit.
Push the spouts firmly all the way
round so that the dispensing unit is
firmly seated in the groove.
To Next Page
Loading...
Need help?
General
