Cleaning and care
74
Clean the surfaces of the central
spout with a damp cloth.
Clean any blockages in the milk
pipework under running water with the
special brush supplied:
Insert the brush in the pipework.
Move it back and forth until all milk
residue has been removed.
Reassembling the central spout
The dispensing unit is easier to
reassemble if the individual parts are
dampened with water beforehand.
Fit the dispensing unit back together.
Push the spouts firmly back onto
the dispensing unit.
Make sure that all parts are tightly
connected to one another.
Push the dispensing unit back into
the central spout and replace the
stainless steel cover.
Touch OK.
Tip: If the coffee machine is switched
off, the central spout components can
be removed and cleaned at any time.
Removing and cleaning the
cup sensor
The cup sensor is located under the
central spout.
Clean the cup edge sensor daily by
hand with warm water and a little
washing-up liquid.
Press the two retainers together (see
arrows).
The cup edge sensor is released.
Clean the cup edge sensor.
Refitting:
Press the cup edge sensor from
below into the holder on the central
spout.
To Next Page
Need help?
General
