Miele Compact C1 User Manual

en
42
How to change the motor protection
filter (dia. 33)
 Open the dust compartment lid.
 Pull the dustbag out by the grip on
the collar.
 Lift up the filter frame until it clicks
and remove the old filter. Hold by the
clean, unsoiled section to remove it.
 Replace with a new motor protection
filter.
 Close the filter frame.
 Fit the dustbag into the holder as far
as it will go.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
When to replace the exhaust filter
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
12).
a AirClean
Replace this filter every time you start a
new packet of dustbags. Every packet
of original Miele dustbags contains one
AirClean exhaust filter. Multipacks con-
tain four AirClean filters.
b Active AirClean 50 (black)
c AirClean Plus 50 (light blue)
d HEPA AirClean 50 (white)
Replace this filter when the exhaust fil-
ter timestrip indicator is completely red
(dia. 17). The indicator lights up after
approximately 50 hours of operation
which is equivalent to about a year of
average use. You can continue vacuum-
ing when the light comes on. However,
the suction power will be reduced as
will the effectiveness of the filter if it is
not replaced in good time.
How to replace the AirClean exhaust
filter (dia. 34 + 35)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Open the filter grille.
 Grasp the used AirClean filter by the
clean, unsoiled section and take it
out.
 Replace it with a new AirClean filter.
If you wish to fit an Active AirClean
50, AirClean Plus 50 or HEPA
AirClean 50 filter, see "Maintenance -
Replacing one type of exhaust filter
with another".
 Close the filter grille.
 Close the dust compartment lid.
Replacing the Active AirClean 50,
AirClean Plus 50 and HEPA AirClean
50 exhaust filters (dia. 36 + 37)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter making it
sure it goes in properly, then push it
down into position.
 Press the exhaust filter timestrip in-
dicator (dia. 15).

Miele Compact C1 Specifications

General

Power control	Electronic
AC input voltage	230 V
Maximum input power	800 W
Annual energy consumption	30.2 kWh
Type	Cylinder vacuum
Cordless	No
Cleaning type	Dry
Dust capacity	3.5 L
Product color	Red
Tube material	Metal
Tube lock type	Button
Dust container type	Dust bag
Proper use	Home
Noise level	77 dB
Cleaning surfaces	Carpet, Hard floor
Vacuum air filtering	Miele AirClean
Dirt separating method	Filtering
Motor protection filter	Yes
Cord length	5.5 m

Weight and Dimensions

Depth	250 mm
Width	429 mm
Height	230 mm
Weight	4800 g