Miele Complete C3 Active User Manual

en
61
When to replace the battery in the
LED handle
Replace the batteries when necessary.
3 1.5V batteries (AAA) are required.
How to change the battery in the LED
handle (Fig. 06+07)
 Loosen the screw on the cover.
 Press in the sides of the cover to re-
lease the retainers and remove the
cover.
 Take out the battery holder and in-
sert the 3 batteries supplied. Make
sure the polarity is correct.
 Refit the battery holder. Arrows are
marked on the battery holder and
battery compartment as a fitting aid.
They should point in the same direc-
tion.
 Replace the cover and tighten the
screw back up again.
Replacing the thread lifters (Fig. 45)
(not possible on EcoTeQ Plusfloor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Replace
the thread lifters if the pile has worn
down.
 Lever the thread lifters from the slots.
To do so use a suitable tool, e.g. a flat
blade screwdriver.
 Fit new thread lifters.
Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.
Cleaning and care
 Risk of electric shock from mains
voltage.
The mains voltage is applied to the
appliance even if it is switched off.
Before cleaning, switch the appli-
ance off at the wall socket and un-
plug it.
Vacuum cleaner and accessories
 Risk of electric shock from mains
voltage.
If moisture gets into the vacuum
cleaner, there is a risk of electric
shock.
Do not let the vacuum cleaner get
wet.
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.
 Damage due to unsuitable clean-
ing agents.
All surfaces are susceptible to
scratching. Contact with unsuitable
cleaning agents can alter or discol-
our the external surfaces.
Do not use abrasive cleaning agents,
glass cleaning agents, all-purpose
cleaners or oil-based conditioning
agents.
Dust compartment
The dust compartment can, if neces-
sary, be cleaned using a dry duster,
brush or, if available, a second vacuum
cleaner to vacuum the dust out.

Miele Complete C3 Active Specifications

General

AC input voltage	230 V
AC input frequency	50 - 60 Hz
Maximum input power	890 W
Annual energy consumption	- kWh
Cord length	8.5 m
Dust container full indicator	Yes
Type	Cylinder vacuum
Cleaning type	Dry
Dust capacity	5 L
Product color	Red
Tube lock type	Click
Number of wheels	3 wheel(s)
Dust container type	Dust bag
Proper use	Home
Noise level	- dB
Cleaning surfaces	Carpet, Hard floor
Vacuum air filtering	Miele AirClean
Dirt separating method	Filtering

Weight and Dimensions

Depth	284 mm
Width	496 mm
Height	227 mm
Weight	7300 g
Package depth	320 mm
Package width	590 mm
Package height	380 mm
Package weight	8700 g