Miele Complete C3 Active User Manual

en
62
Problem solving guide
Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Problem Cause and remedy
The vacuum cleaner
switches off automatic-
ally.
On certain models, the
overheating protection
warning light also
comes on.
A temperature limiter switches the vacuum cleaner
off automatically if it gets too hot.
This can occur if, for instance, large articles block the
suction tube or when the dustbag is full or contains
particles of fine dust. A heavily soiled motor protec-
tion or exhaust filter can also be the cause of over-
heating.
 Switch the vacuum cleaner off immediately using
the On/Off footswitch. Switch off at the wall
socket and unplug it.
After removing the cause, wait for approximately 20–
30 minutes to allow the vacuum cleaner to cool
down. It can then be switched on again.
Technical data
(for models with radio controlled handle)
Frequency band 433.05 MHz – 434.79 MHz
Maximum transmitting power <10µW

Miele Complete C3 Active Specifications

General

AC input voltage	230 V
AC input frequency	50 - 60 Hz
Maximum input power	890 W
Annual energy consumption	- kWh
Cord length	8.5 m
Dust container full indicator	Yes
Type	Cylinder vacuum
Cleaning type	Dry
Dust capacity	5 L
Product color	Red
Tube lock type	Click
Number of wheels	3 wheel(s)
Dust container type	Dust bag
Proper use	Home
Noise level	- dB
Cleaning surfaces	Carpet, Hard floor
Vacuum air filtering	Miele AirClean
Dirt separating method	Filtering

Weight and Dimensions

Depth	284 mm
Width	496 mm
Height	227 mm
Weight	7300 g
Package depth	320 mm
Package width	590 mm
Package height	380 mm
Package weight	8700 g