Main dispenser
^ Pull the main dispenser all the way
down a and pull the cover forward to
remove b.
^ Turn the cover around, slide the
insert upward and out, and clean
both parts thoroughly.
^ Slide the insert back into the cover
until it clicks into place.
^ Pull the nozzles of the main
dispenser out.
^ Pull both rubber stoppers a out and
clean the stoppers and nozzles
thoroughly.
^ Pull the air intake pipe b out if
necessary. You can knead or blow
through the pipe to remove any
potential blockages.
Never use a sharp object to remove
blockages, this could damage the
parts.
^ Put the rubber stoppers back into
place.
^ After cleaning the nozzles of the main
dispenser, slide them back into the
machine firmly upward to ensure they
are securely in place.
^ Replace the cover and slide the main
dispenser up.
Cleaning and care
46
To Next Page
Loading...
Need help?
General
