^
Fit the descaling funnels under the spouts as illustrated.
The bottom of the funnel fits into the drip tray to enable the
descaling agent to be collected in it.
During the descaling programme, water containing descaling
agent will run out of the hot water and the cappuccinatore
spouts. This is followed by an activation period before a little
more descaling agent is dispensed.
^ When a message asking you to fill the water container
with fresh water appears, you should remove the
container and rinse it out thoroughly with clean water. Make
sure all traces of descaling agent are removed, and then fill
it up to the k mark with clean tap water.
Water will flow out of the spouts during the rinsing process.
The drip tray will need to be emptied several times during
this process.
When descaling has been completed, Programme finished
will appear in the display. Follow the instructions in the
display. The machine will then run a short rinsing cycle.
The pipework is completely pumped out during the
descaling process. For this reason, water must be
pumped back into the pipework before using the machine
to make a cappuccino or to froth milk after descaling. (See
"Making coffee: Cappuccino and milk froth").
Descaling the machine
67
To Next Page
Loading...
Need help?
General
