Operation (Automatic and Manual modes)
31
Altering or deactivating the charcoal
filter operating hours counter
Charcoal filters are needed for
recirculation mode.
You can set the operating hours counter
to suit the type of cooking you do.
It has to be deactivated for extraction
mode.
It is set at the factory for 180hours of
use before the filters need replacing.
Switch off the fan and the lighting.
Press the control and the operating
hours control at the same time.
The charcoal filter symbol and one of
the fan power levels will flash.
Fan power level indicators 1 to B show
the time set:
Indicator 1 ............................. 120hours
Indicator 2 ............................. 180hours
Indicator 3 ............................. 240hours
Indicator B.......................... deactivated
Select the duration you want with
the or control.
Confirm your choice with the
operating hours control.
All the indicator lights will go out.
If you do not confirm your selection
within 4minutes, the cooker hood will
automatically revert to the original
setting.
Reading the filter operating hours
counter
You can check the percentage of time
set already used before the filter needs
replacing.
Switch the fan on with the On/Off
control.
Press and hold the operating hours
control :
- Once, to read the grease filter
operating hours. The grease filter
symbol lights up.
- Twice, to read the charcoal filter
operating hours. The charcoal filter
symbol lights up.
One or more of the fan power level
indicators will flash.
The number of fan power level
indicators flashing shows the
percentage of the operating time which
has already been used up.
Indicator 1 ................................... 25%
Indicators 1 and 2 ........................ 50%
Indicators 1 to 3 .......................... 75%
Indicators 1 to B ........................ 100%
The number of operating hours used
remains in the memory, even when the
cooker hood is switched off or there is
a power cut.
To Next Page
Loading...
Need help?
General
