The Miele DSM 400 control module
(optional accessory) can be used to
combine the cooker hood with other
components.
It enables the following:
Potential free connection
This can be used to operate another
appliance by pulling out the deflector
plate and using the On/Off button s of
the cooker hood.
The potential free contact on the
DSM 400 a can, for example, be used
in a cooker hood with an external motor
...EXT, which is connected to a central
ducting system.
The contact can then be used to
operate an electrically driven non-return
flap b which is connected to the
central extraction unit c.
Components used in the central
ducting system are not supplied by
Miele.
If in any doubt, the advice of a
competent builder or, for gas, a Gas
Safe installer must be sought.
Connection to a push button switch
The control module can be used to
switch on the cooker hood lighting
when the deflector plate is pulled out
via a push button switch in the house.
Installation
The control module must be installed at
the back of the the cooker hood
housing.
The electrical connection of
components to the control module
must be carried out by a suitably
qualified and competent person.
Operation with Control module DSM 400
42
To Next Page
Loading...
Need help?
General
