With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repairs should only be carried out by a suitably qualified and trained
person in strict accordance with current local and national safety regulations.
Unauthorised or incorrect repairs could cause personal injury or damage to the
appliance.
Technical problems
Problem Possible cause Remedy
The display remains
dark and the Standby
indicator light is not
flashing after the
dishwasher has been
switched on with the K
sensor.
The appliance is not
plugged in.
Insert the plug and switch
on at the socket.
The mains fuse has
tripped.
Reset the trip switch or
replace the fuse in the
plug.
(Minimum fuse rating - see
data plate).
The dishwasher stops
during a programme.
The mains fuse has
tripped.
– Reset the trip switch or
replace the fuse in the
plug (minimum fuse
rating - see data plate).
–
If the mains fuse trips
again, call the Miele Ser
-
vice Department.
Problem solving guide
54
To Next Page
Need help?
General
