Problem Possible cause Remedy
In the display for the
Without heater
programme, the
following fault
message appears:
Water intake temp. too
low
The intake water has not
reached the required
temperature of 45 °C (see
"Connection to the
water supply").
–
Start the programme
again.
–
If the fault message
appears again, select a
different programme.
The buzzer sounds.
The following fault
message appears in
the display:
Drain fault F11
Before rectifying the
problem:
–
Switch the dishwasher off
with the K sensor.
The water outlet is
restricted, water remains
in the wash cabinet at the
end of a programme.
–
Clean the filter
combination. See
"Cleaning and care".
– Clean the drain pump. See
"Maintenance".
– Clean the non-return valve.
See "Maintenance".
– Remove any kink in the
drain hose.
Problem solving guide
57
To Next Page
Loading...
