Before using for the first time
^
Clean the inside of the appliance and
the accessories with luke warm water
and a little washing-up liquid, and
then dry with a soft cloth.
Important:
To ensure the correct functioning of
the appliance, let it stand for
between 1½ and 2 hours after
transporting it to its final location
before connecting it to the mains.
Switching on
^ Using a coin turn the On/Off dial in a
clockwise direction away from the "0"
position.
Forcing it beyond its range will
damage it. Turn it only as far as it
will go, then turn it back again.
The temperature display and the alarm
button indicator will light up. An alarm
will sound after a short while and the
appliance will start cooling.
To enable the temperature to get
sufficiently cold inside the freezer, allow
the appliance to run for a few hours
before placing food in it.
The higher the setting, the lower the
temperature in the appliance.
Switching off the alarm
^
Press the alarm button.
The alarm will stop.
The alarm indicator will remain lit until
the set temperature is reached.
Switching off
^ Using a coin, turn the On/Off dial in
an anti-clockwise direction back to
the "0" position.
All the indicator lights will go out and
the cooling system will switch off.
Switching off for longer
periods of time
If the appliance is not going to be used
for a longer period of time, e.g. whilst
on holiday,
^
switch the appliance off,
^
switch off at the wall socket and
withdraw the plug,
^
defrost and clean the appliance out
and
^
leave the door ajar to air the
appliance.
Operation
12
To Next Page
Loading...
Need help?
General
