General problems
Problem Possible cause Remedy
Detergent residue is left
in the dispenser at the
end of a programme.
The dispenser was still
damp when detergent
was added.
Make sure the dispenser is
dry before adding
detergent.
The detergent
dispenser lid cannot be
closed properly.
Clogged detergent
residue is blocking the
catch.
Clean the detergent from
the catch.
At the end of a
programme there is a
film of moisture on the
inside of the door and
the interior walls.
This is caused by the
drying system and does
not indicate a fault.
The moisture will dissipate
after a short while.
Water remains in the
wash cabinet at the end
of a programme.
Before rectifying the
problem you must:
– Switch the dishwasher
off using the K button.
The filter combination in
the wash cabinet is
clogged.
Clean the filter
combination. See
"Cleaning and care".
The drain pump or
non-return valve may be
blocked.
Clean the drain pump or
the non-return valve. See
"Maintenance".
The drain hose is kinked. Remove any kink from the
drain hose.
Problem solving guide
44
To Next Page
Loading...
Need help?
General
