Factory default setting
If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^
Switch the dishwasher off with the
On/Off button s.
^
Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on with the On/Off button
s.
Keep the Start/Stop button pressed in
for at least four seconds until the
Start/Stop indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Delay start button twelve
times.
The Delay start indicator light will give
one long flash and two brief flashes at
intervals and "p 0" or "p 1" will flash in
the display.
The characters flashing in the display
show whether a setting other than the
factory default setting has been set.
–
"p 1": All settings are set to factory
default settings.
–
"p 0": At least one setting has been
changed.
^
Press the Start/Stop button if you
wish to re-set all the factory default
settings.
^
Switch the dishwasher off with the
On/Off button s.
Operation
41
To Next Page
Loading...
Need help?
General
