The dishwasher does not fill/drain
Problem Possible cause Remedy
The buzzer sounds.
The Inlet/Drain check
indicator flashes.
The stopcock is
closed.
Open the stopcock fully.
The buzzer sounds.
The dishwasher stops
during a programme.
The Inlet/Drain check
indicator flashes.
Fault code FXX shows
in the display.
Before rectifying the problem
you must:
–
Switch the dishwasher off
with the On/Off button s.
Fault F12/F13:
Water inlet restricted.
–
Open the stopcock fully.
–
Clean the water inlet filter
(see "Problem solving").
– The water pressure at the
intake is lower than 30 kPa
(0.3 bar).
Seek professional advice.
Fault F11:
Water outlet is
restricted, water
remains in the wash
cabinet at the end of a
programme.
– Clean the filter combination.
See "Cleaning and Care".
– Clean the drain pump. See
"Problem solving".
– Clean the non-return valve.
See "Problem solving".
–
Remove any kink in the drain
hose.
Problem solving guide
50
To Next Page
Loading...
Need help?
General
