Miele G 5051 - Setting Rinse Aid Dosage

Initial commissioning
22
Filling the rinse aid reservoir
When the refill reminder Rinse aid
appears in the display, the reservoir
contains sufficient rinse aid for 2 to 3
programs only.
 Add rinse aid in plenty of time.
The rinse aid refill reminder will go out.
If you only ever use combination
detergent products containing rinse
aid in your dishwasher, you can turn
off the refill reminder if you wish (see
“Turning off the refill reminders” under
“Options”).
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from 0
to 6ml.
3ml is the factory default setting.
The rinse aid dosage can turn out to be
higher than the set value due to the
automatic adjustment of the program.
If spots appear on dishware:
- Increase the rinse aid dosage.
If clouding or smearing appears on
dishware:
- Decrease the rinse aid dosage.
 Open the door.
 Turn the dishwasher off with the
button, if it is turned on.
 Press the button in and, while
holding it in, turn the dishwasher on
using the button.
Keep the button pressed in for at
least 4seconds until the indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
 Press the Program button 3times.
The top left program indicator light will
flash rapidly 3times at intervals.
The set value will appear in the display
after.
 will start flashing in the time display.
Setting3 is set.
 Use the button to select the
required setting.
The dosage amount increases each
time you press the button. When the
highest value is reached, the setting
starts again from the beginning.
The setting is now saved.
 Turn the dishwasher off with the
button.