Miele G 5051 User Manual

Frequently Asked Questions
65
Water intake fault
Problem Possible cause and solution
The dishwasher stops
working shortly after
the program starts.
The alarm tone is
sounding.
The / indicator
light flashes on and off.
 and 173 appear
alternately on the time
display.
The water supply faucet is turned off.
 Turn on the water supply faucet fully.
The dishwasher stops
during a program.
The alarm tone is
sounding.
The / indicator
light is flashing.
The fault number  or
 appears in the
display.
Before remedying the fault:
 Turn the dishwasher off with the button.
There is a problem with the water intake.
 Turn on the water supply faucet fully and start the
program again.
 Clean the filter in the water intake (see “Cleaning
the filter in the water intake” under “Cleaning and
care”).
 The water connection pressure is lower than
50kPa.
Seek professional advice.
 The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Water drainage” under
“Installation”).
The dishwasher stops
during a program.
Fault number8
appears in the time
display.
A technical fault has occurred.
 Turn the dishwasher off.
 Close the faucet.
 Contact Miele Service.

Miele G 5051 Specifications

General

Brand	Miele
Model	G 5051
Category	Dishwasher
Language	English