Installation
*INSTALLATION*
91
Risk of damage from leaking wa-
ter.
The connection point is subject to
mains water pressure. Water leaking
from it can cause damage.
You should therefore open the stop-
cock slowly and check for leaks.
Correct the position of the seal and
screw thread if appropriate.
Regulation in Germany
For the protection of drinking water, the
non-return valve supplied with the dish-
washer must be installed between the
stopcock and the water inlet hose.
Screw the non-return valve onto the
stopcock.
Screw the water inlet hose onto the
thread of the non-return valve.
Risk of damage due to excessive
pressure.
A brief increase in the water pressure
can damage components of the
dishwasher.
This dishwasher must only be oper-
ated when it is connected to a fully
vented plumbing system.
Risk of electric shock from mains
voltage.
There are electrical components in
the water inlet hose.
The inlet hose must not be shortened
or damaged in any way (see illustra-
tion).
To Next Page
Loading...
Need help?
General
