Miele G 575 User Manual

If you turn the dial past the ‘Start’
point by mistake:
@® Turn the right-hand (temperature
selector) switch to ‘0’.
@ Turn the program sequence
switch clockwise to the required
start point.
® Re-select the temperature.
The program sequence switch
During the program, the program
sequence switch moves around the
dial to show which stage has been
reached:
— Pre-wash (not shown)
— Main wash
- Interim rinse
— Final rinse
— Drying
The program sequence switch re-
mains stationary during the warm-up
phases of the wash and rinse cycle
until the required temperature has
been reached.
A program is complete only when the
program sequence switch is at the
position “End (@).
The Rinse-hold program is complete
when the program sequence switch
stops just before the ‘Start’ point of
the INTENSIVE program.
WARNING
Do not try to take short-cuts by
turning the program sequence switch
past stages in a program. This can
lead to important functions being in-
terrupted.
Switching ON and OFF
Switching OFF
Upon completion of a program:
@ Turn the temperature selector to ‘0’.
Changing a program
It is possible to change the tem-
perature within a program, eg.
NORMAL 55° C/130° F tao NORMAL
70° C/160° F or ECONOMY 55° C/
130°
F
ta
ECONOMY
70°
C/160°
F
If
changing a program, eg. INTENSIVE
to NORMAL it is advised to first turn
the appliance off.
To interrupt a program
The program is interrupted immedi-
ately when the door is opened. When
the door is shut, the program con-
tinues from the point where it was
interrupted,
Take care.
lf the water in the dishwasher is
hot, there is a danger of scalding.
Only
open
the
door
if
absolutely
—
necessary, and then with greatest —
scare. |
Important
Lean, but do not close the door for 20
seconds before firmly shutting the
door.
This
will
keep
a
balanced
tem-
perature inside the wash cabinet.
23

Miele G 575 Specifications

General

Brand	Miele
Model	G 575
Category	Dishwasher
Language	English