Increasing the water intake
time
If the water pressure is lower than
1.0 bar, too little water will flow into the
wash cabinet (see “Checking the water
level”). In this case the water intake
time must be increased.
Proceed as follows:
Switch the dishwasher off using the
“On/Off” button.
Turn the programme selector to
“Stop”.
Press the “Start” button in and whilst
doing so
at the same time switch the
dishwasher on using the “On/Off”
button. Release the “Start” button
again within two seconds.
The “Salt” indicator light will start flash-
ing
Note:
If a different indicator light is on or flash-
ing, the process must be repeated.
Exception:
The “Rinse aid” indicator light will come
on if you have not yet added rinse aid
or if rinse aid needs replenishing.
Turn the programme selector to the
“Economy 45°” setting.
– If the “Start” indicator light does not
come on, then the water intake time
is set to the standard time,
– If the “Start” indicator light comes
on: then the water intake time is set
to increased intake time.
Press the “Start” button to change
the setting.
Depending on the previous setting, the
“Start” indicator light will either come
on or remain switched off.
Turn the programme selector to the
“Stop” position.
Switch the dishwasher off using the
“On/Off” button.
The modified water intake time is now
stored in memory.
Solving problems
52
To Next Page
Loading...
Need help?
General
