Solving problems
Cleaning the water intake filter
A filter is incorporated in the intake
hose attached to the dishwasher’s shut
-
off valve. If your water is hard, or the
pipes contain sediment; this filter may
clog and prevent enough water from
entering the wash cabinet. It can be
cleaned as follows:
The plastic valve housing on the in
-
take hose contains electrical com
-
ponents and should not be im
-
mersed, or run through water.
Cleaning the filter:
Disconnect the dishwasher from
electricity (unplug it or “trip” the circuit
breaker).
^ Turn off the main shutoff valve and
unscrew the intake hose.
^ Carefully remove the rubber seal.
^ Remove the filter using needle nose
pliers and rinse under running water.
^
Return the filter and seal. Make sure
they are seated correctly.
^ Screw the intake hose back on the
water valve, checking that it is not
cross-threaded.
^ Slowly turn on the valve and test for
leaks.
Installing an in-line water filter
^ If your water contains a large number
of insoluble substances, a filter be
-
tween the valve and the intake hose
connection is recommended. These
filters can be purchased from the
Miele Technical Service Department.
Solving problems
52
To Next Page
Loading...
Need help?
General
