Factory default
If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^
Switch the dishwasher off using the
On/Off button K.
^
Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button K.
Keep the Start/Stop button pressed in
until the Start/Stop indicator light
comes on.
If this does not happen, start the
procedure again from the beginning.
^ Press the Delay start button twelve
times.
The Delay start indicator light will give
one long flash and two brief flashes at
intervals.
The flashing sequence in the display
shows what the current setting is.
–
"p1": All settings are set to factory
default settings.
–
"p0": At least one setting has been
changed.
^
To reset the dishwasher to the factory
default settings, press the Start/Stop
button.
The setting is now stored in memory.
^
Switch the dishwasher off using the
On/Off button K.
Additional functions
49
To Next Page
Loading...
Need help?
General
