Programme options
63
Factory default settings
If you have altered any settings from the
factory default, you can reset them
back to the factory default settings as
follows:
Open the door.
Switch the dishwasher off with the
button, if it is switched on.
Press the programme selector button
in and, whilst holding it in, switch
the dishwasher on using the
button.
Keep the programme selector button
pressed in for at least 4 seconds
until the lower right-hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
Press the Turbobutton 12 times.
The Turboindicator light will do 1 long
flash and 2 short flashes at intervals.
The flashing sequence in the display
indicates whether a setting has been
changed from its factory default.
– : All settings are set to factory
default settings.
– : At least one setting has been
changed.
To reset the dishwasher to the factory
default settings, press the
programme selector button.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
To Next Page
Loading...
Need help?
General
