You can delay the actual start of a
programme by up to 23 hours and
59 minutes after programming a pro
-
cess.
^
Make sure the correct time of day
shows in the display before starting
(refer to "Setting the time of day"),
and that the door is shut.
^
Enter the process required.
All operating modes and
programmes can be pre-selected.
^
Press the m touch control once be
-
fore starting the process.
The text/symbol for "Start time" will light
up in the display. The time of day will
appear in the display.
^
Enter the start time you require using
the "+" touch control.
If you press the "+" touch control for too
long by mistake, use the " –" touch con
-
trol to correct the start time.
^
Begin the programme by pressing
the Start touch control.
The time of day will reappear in the dis
-
play. The text/symbol for "Start time" will
light up. The stored entries will appear
in the display area for selected settings.
If delaying the start of a programme
stored using the "Memory function", the
entries for the M1 Programme will be
displayed.
Press the m touch control at any time
and the selected start time will reap-
pear in the display.
This will light up for approx. 4 seconds
and will then be replaced by the time of
day.
The interior light does not come on dur-
ing the delay start time. You can switch
the oven compartment light on for a
short while by pressing the Enter touch
control. The oven light will go off again
automatically after approx. 10 seconds.
If you press the Stop/C touch control
during the period running up to the
start time all entries are cancelled.
Automatic delay start
41
Enter
To Next Page
Loading...