Catalytic enamel surfaces
The removable back panel, side panels
(if fitted) and roof liner are coated with a
dark grey catalytic enamel.
During fan operated cooking,
circulating air in the oven deposits oil
and fat splashes predominantly on the
back panel of the oven. These splashes
are burnt off when the temperature of
the oven reaches over 200°C during
baking or roasting. The higher the
temperature the more effective the
process.
The oven and accessories should be
cleaned after each use. Otherwise
further baking and roasting will cause
the deposits to bake on even harder
and cleaning may become difficult and
in extreme cases impossible.
Cleaning by hand
Allow the oven to cool down before
cleaning. Danger of burning!
^
Catalytic enamelled panels should be
cleaned using a solution of hot water
with a little washing-up liquid applied
with a soft nylon brush.
Do not use abrasive cleaning agents,
hard brushes, scouring pads or cloths,
steel wool, knives or other abrasive
materials and do not use oven spray on
catalytic enamel as the chemicals used
in oven sprays will damage catalytic
enamel rendering it ineffective.
If using oven sprays on PerfectClean
oven surfaces the catalytic back panel,
roof liner and side liners (if fitted) must
first be removed from the oven.
Cleaning and care
52
To Next Page
Loading...
Need help?
General
