Installation, maintenance and repairs
may only be carried out by suitably
qualified and competent persons in
accordance with local and national
safety regulations.
Repairs and other work by
unqualified persons could be
dangerous, and the manufacturer
will not be held liable for
unauthorised work.
Ensure current is not supplied to the
appliance until after maintenance or
repair work has been carried out.
Some minor problems can be corrected
without contacting the Miele Service
Department.
What to do if . . .
. . . the oven does not heat up.
Check whether,
^
the system lock has been activated.
^
the mains fuse has tripped. Contact a
qualified electrician or the Miele
Service Department.
. . . the heating works, but not the
oven lighting.
The halogen lamp needs replacing.
To change the lamp:
^
Disconnect the appliance from the
electricity supply.
Switch off and unplug at the socket,
or remove the fuse, or switch off at
the isolator as appropriate.
^
Remove the runners.
^
Cover the floor of the oven with a
towel to protect the enamelling just in
case the lamp cover is dropped.
^ Use the lever to release the lamp
cover from its frame.
The glass cover is held in position by
two metal brackets which are secured
to the reflector.
Do not push the metal brackets to
the sides, as this would damage
both the brackets and the reflector.
It might also make it difficult to push
the glass cover back into its frame
again.
Problem solving guide
46
To Next Page
Loading...
Need help?
General
