Do not attempt to use on a hot oven or
accessories. Allow the PerfectClean
surfaces to cool down to room
temperature before applying an oven
spray.
Apply a spray oven cleaner to the
soiled areas. Leave to take effect for a
couple of minutes only!
If necessary use a soft sponge, soft
nylon brush or a scraper suitable for
glass surfaces to loosen the soiling.
Repeat the process if necessary.
After cleaning, rinse thoroughly with
clean water and then dry thoroughly.
For optimum performance of
PerfectClean enamel it is important to
clean the oven and accessories after
each use.
The surfaces will become harder to
clean and the anti-stick properties will
deteriorate if soiling is not removed
after each use and allowed to build up.
In extreme cases cleaning may
become impossible.
The following cause lasting damage
to the surface structure and reduce
the anti-stick effect and must not be
used on PerfectClean surfaces:
–
abrasive cleaning agents, e.g.
powder cleaners and cream
cleaners,
–
cleaning agents for ceramic hobs,
–
wire wool or metal scourers,
–
abrasive sponges, e.g. pot scourers
or sponges which have been
previously used with abrasive
cleaning agents,
– oven spray must not be used in a hot
oven or left on for too long,
– PerfectClean enamelled items must
not be washed in a dishwasher.
Note:
– Soiling such as spilt juices and cake
mixtures are best removed whilst the
oven or tray is still warm. Exercise
caution, make sure the oven is not
too hot - danger of burning.
–
Spilt fruit juices may cause lasting
discolouration to the surfaces and
roasting can cause matt areas to
appear. Clean these following the
instructions given above and do not
use force to remove them. This
discolouration is permanent but will
not affect the efficiency of the
enamel.
Cleaning and care
58
To Next Page
Loading...
Need help?
General
Weight and Dimensions
