Cleaning the water inlet filter
A filter is incorporated into the intake
hose attached to the dishwasher’s shut
off valve. If your water is hard or the
pipes contain sediment, this filter may
clog and prevent enough water from
entering the wash cabinet.
,
The plastic housing of the water
connection contains electrical
wiring. Do not submerge the
housing in liquid.
Do not cut the intake hose or
submerge it in liquid.
Installing an in-line water filter
If your water contains a large number of
insoluble substances, a filter between
the water valve and the intake hose
connection is recommended. These
filters can be purchased from Miele.
Cleaning the filter
^ Turn off the dishwasher and pull the
plug.
^
Turn off the water supply.
^
Unscrew the intake hose.
^
Carefully remove the rubber seal.
^ Remove the filter using needle nose
pliers and rinse it under running
water.
^ Reinsert the filter and seal. Make sure
they are seated correctly.
^ Screw the intake hose back on the
water valve, checking that it is not
cross-threaded.
^
Slowly turn on the water supply and
test for leaks.
Cleaning and Care
46
To Next Page
Loading...
Need help?
General
