The appliance can be pushed
underneath a worktop run. If this is
done, then the top lid to the appliance
may need to be removed:
^
Remove screws a from the rear of
the appliance.
^ Lift the appliance lid up at the rear
and then pull it towards the front of
the appliance to remove it.
When placed under a worktop run it
is essential that adequate ventilation
is provided at the rear of the
appliance. A ventilation gap of at
least 140 cm
2
must be made in the
worktop.
With a building under depth of
600 mm, any backmould must not
exceed 10 mm in depth.
Make sure that the socket and on-off
switch are easily accessible after the
appliance has been pushed
underneath the worktop.
Building under
35
To Next Page
Loading...
Need help?
General
