Power failure - Emergency door
release
During a short power failure
The program remains in the last position.
When power is restored the following
message appears in the display:
y
Power failure
Program stop
Press Start.
f
^
Press h "Start" to continue the program.
Extended power failure
^
Turn the machine off.
^
Turn the electrical supply off at the mains.
^ Close the steam valve (on-site).
The machine must be drained and the drum
door opened manually to unload the
machine.
Draining the wash water
^
Place a container under the manual drain
at the rear of the machine.
^
Open the drain by loosening the venting
screw. Do not take it completely out.
^
A small amount of water from the machine
will drain.
^
Tighten the venting screw again and test
for leaks by opening the water supply.
Open the door manually
^ Insert and hold a small screwdriver in the
opening next to the door lock.
^
Press against the door handle, then pull it
towards you to open the door.
Do not use force!
^
Remove the laundry.
Frequently asked questions
31
To Next Page
Loading...
Need help?
General
